INSTALLATION
MOUNT
To install the GPS Windshield Mount, connect the dash cam onto the mount. Remove protective film
from camera lens. Find the spot on your windshield where you would like to mount the camera and
confirm the placement. Reminder, this is an adhesive mount, so it is important to mount correctly the
first time. Next, peel the plastic film off the 3M adhesive and press the mount FIRMLY onto the
windshield.
POWER
Plug one end of the supplied 12V Vehicle Power Adapter into your vehicle’s cigarette lighter, and the
other end into the micro USB port. The unit will automatically turn on and start recording. To manually
power on the device PRESS AND HOLD the Power button until the LED’s activate.
Note: A Hardwire Kit (CA-MicroUSB-001) is available at www.cobra.com for a more permanent installation
that allows for discrete routing of the power cable and recording while your vehicle is off.
DRIVE!
The dashcam is designed for easy operation. After powering the camera will instantly
begin loop recording. When the MicroSD Card is full the oldest footage will be deleted to
make way for the new. If you witness something that you do not want deleted simply
press the Emergency Record button and it will be saved.
To Next Page
Loading...
