Cobra SPYBALL 6829 - Page 17

17
- Anti-hijack function (see paragraph 10)
- Polarity of instantaneous alarm trigger input (this selection should be set up by the
installer and must not be altered by the user once the security system has been fitted).
Procedure:
While the security system is disarmed, turn ignition on, press and hold down push-button n. 1
of the transmitter about 7 seconds, until the LED lights up, then release.  The LED remains
on about 3 seconds.  During this lapse of time, press push-button n. 1 again.  A short
sharp audible signal confirms that the procedure has been initiated. The LED switches off, and
then provides five different visual indications that relate to the five selectable functions. Please
refer to the chart below:
VISUAL
INDICATION
SELECTABLE
FUNCTION
TO SELECT
TO DESELECT
CONFIRMATION
SIGNAL
CONFIRMATION
SIGNAL
1 flash
Biker Recognition
Press push-button n. 1 of
the transmitter after the
first flash
Three (3) sharp audible
signals follow
Press push-button n. 2 of
the transmitter after the
first flash
One (1) sharp audible
signal follows
2 flashes
Arming and disarming
audible signals
Press push-button n. 1 of
the transmitter after the
second flash
Three (3) sharp audible
signals follow
Press push-button n. 2 of
the transmitter after the
second flash
One (1) sharp audible
signal follows