Coca-Cola Freestyle 7100 - Cleaning and Filling Ice bin

© 2020 The Coca-Cola Company | Coca-Cola Freestyle® 7100 User Guide | Confidential information of The Coca-Cola Company | 20200821 |
17
maintenance
cleaning and lling ice bin
/ full
/ full
full
Ice bin should NEVER be less
than one-third full
How to check/refill ice
Maintaining the proper ice level is critical to
ensuring your guest receives a quality beverage.
If using a top-mount ice maker, follow established
procedures for checking ice level. If you fill the ice
manually, check to ensure ice is at least 1/3 full
at all times. Fill the ice bin by following the steps
illustrated below:
Power o the dispenser and fill a clean bucket with ice.
Safely lift and remove ice bin lid and place on ice lid hook.
Dump the ice in the ice bin and fill until full.
(approximately 2" from the top – do not overfill)
Replace ice bin lid.
NOTE: Store bought or “bagged ice” SHOULD NEVER BE USED as it may
seriously damage the Coca-Cola Freestyle® 7100 dispenser ice bin.
Ice bin cleaning best practices
Remove ALL ice by using the ice dispense lever
(if a top mounted ice maker is installed, follow
manufacturer’s recommendation for cleaning).
Turn power o and unplug dispenser.
Remove ice bin lid.
Pour warm water slowly into the bin (not over
the ice chute) to melt the remaining ice on the
cold plate.
Spray approved sanitizer solution (Kay-5) onto
all internal surfaces of ice bin and both sides of
ice bin lid.
Clean areas within reach inside the bin with
either a clean cloth or an ice bin brush (small
parts #149322). Spray approved sanitizer solution
on all internal surfaces and lid again, allow
draining and air dry.
Return to normal operation.
NOTE: For complete disassembly instructions,
contact your Coca-Cola representative.