Using Quick Start
NGT Transceiver Getting Started Guide 67
1 Close Quick Start, if required.
Setting up a scan list
To set up a scan list:
1 Open Quick Start.
1 Scroll to Set scan list, then press .
The first channel in the transceiver is displayed.
1 If you want to add this channel to the scan list, press .
If you do not want to add this channel to the scan list,
press .
When all the channels have been viewed or you have
added 15 channels to your scan list, the transceiver
returns to Quick Start.
If you do not want to scroll through all the channels in
your scan list, hold to return to Quick Start.
1 Close Quick Start, if required.
NOTE
If you want to make or receive calls on this
new channel, you must add it to your scan
list.
CAUTION
Each time you enter Set scan list, the
resulting scan list overwrites the existing
scan list.
To Next Page
Loading...
Need help?
General
