To Next PageTo Next Page
Need help?Do you have a question about the Codan NGT 2010 RF and is the answer not in the manual?
General| Weight | 4.3 kg (9.5 lb) |
|---|---|
| Dimensions | 240 mm (W) x 80 mm (H) x 280 mm (D) (9.4 in x 3.1 in x 11 in) |
| Channels | 100 |
| Emission Modes | J3E |
| Frequency Range | 1.6 to 30 MHz in 100 Hz steps |
| Supply Voltage | 13.8 V DC nominal (10.8 to 16 V DC) |
| Power Supply | 13.8 V DC nominal (10.8 to 16 V DC) |
Explains the typeface standards and icons used in the manual for emphasis, cross-references, and warnings.
Lists standards and requirements for NGT Transceivers, Power Amplifiers, and Data Modems regarding R&TTE Directive.
Covers radiation safety guidelines and electromagnetic compatibility requirements for optimal transceiver performance.
Details FCC Part 90 and Part 15 certification, including compliance statements and measures for preventing interference.
Provides a general overview and specifications for NGT transceivers, including pin connections for various units.
Offers a detailed technical description of the operation and circuit function of the 2010 RF Unit.
Provides a detailed technical description of the operation and circuit function of the 2011/2012 RF Unit.
Details checks, adjustments, and alignments for the transceiver, including required test equipment.
Describes Codan power amplifier systems for NGT transceivers, including basic layouts and specifications.
Provides detailed technical descriptions of LED indications, power amplifiers, and external high-power systems.
Covers general information, fault finding, and adjustments for power amplifiers and external systems.
Details the NRI's technical aspects, including the User Connect PCB, Microcontroller PCB, and Vocoder PCB.
Covers fault finding procedures for the NRI, including PCB replacement, firmware upgrades, and error messages.
Explains the role of the DSP and CoDec in data modulation, demodulation, and interfacing with the transceiver.
Provides a table for basic fault finding of the 3012 data modem based on conditions like off lights or strange characters.
Explains the receive audio path, including notch filters, amplifiers, and connections to the modem.
Details the transmit audio path, including filters, amplifiers, and connections to the split-site interface.
Explains how microprocessors control the 8571, including the bus structure and signalling methods.
Discusses general fault finding for the split-site remote control system, covering types of faults and voltage measurements.
Details fault finding procedures for situations with no signalling, covering the master 8571, slave 8571, and transceiver.
Guides fault finding for no reception with signalling, suggesting checks of links and shared paths.
Lists figures for specifications, typical values, and measurement conditions for power amplifiers.
Describes the operation and PCB details of the 3061/3062 power amplifier systems.
Details the supply voltages for the 3061/3062 power amplifiers, including control and power supply PCBs.
Details the meaning of front panel LED indicators for fault detection in the 3061/3062 power amplifiers.
Provides procedures for adjusting the driver bias and PA bias for the 3061/3062 power amplifiers.
Guides on adjusting the output power and ALC control of external high-power amplifiers.
