3012—Fault finding
310 NGT Transceiver System Technical Service Manual
Advanced fault finding
It is strongly recommended that fault diagnosis be performed to board level only. If a
faulty board is identified, the complete board should be replaced.
What you need
You may require a multimeter and a pozi-drive screwdriver (1 point) when conducting
fault tests.
Dismantling the data modem
To dismantle the data modem for testing see Figure 5 and follow the procedures below.
WARNING
The following tests should only be performed by a technician familiar
with the HF Data Modem 3012.
WARNING
Removing or substituting components may damage them and/or the
PCBs. In some cases, it is impossible to remove components without
destroying them.
To Next Page
Loading...
