Compliance
NGT Transceiver System Technical Service Manual 19
European Radio and Telecommunications Terminal
Equipment Directive
The NGT series Transceivers have been tested and comply with the following standards
and requirements (articles of the R&TTE Directive):
• Article 3.1b: ETSI EN 301 489-1
• Article 3.1b: ETSI EN 301 489-15
• Article 3.2: Australian type approval according to AZ/NZS 4770:2003 or ECR 209
• Article 3.1a: assessed against ICNIRP and FCC requirements
• Article 3.1a: EN 60950
The 3061/3062 Power Amplifiers have been tested and comply with the following
standards and requirements (articles of the R&TTE Directive):
• Article 3.1b: ETSI EN 301 489-1
• Article 3.1b: ETSI EN 301 489-15
• Article 3.2: Australian type approval according to AZ/NZS 4770
• Article 3.1a: assessed against ICNIRP
• Article 3.1a: EN 60950
• Article 3.1a: EN 50392
The NGT Remote Interface 3030 and HF Data Modem 3012 have been tested and
comply with the following standards and requirements (articles of the R&TTE
Directive):
• Article 3.1b: ETSI EN 301 489-1
• Article 3.1b: ETSI EN 301 489-15
• Article 3.1b: EN 55022 (CISPR 22)
• Article 3.1b: 47CFR15
• Article 3.1a: EN 60950
Product marking and labelling
Any equipment supplied by Codan that satisfies these requirements is identified by the
, , or markings on the model label of the product.
Declarations of Conformity
The CE Declarations of Conformity for this product range available upon request to
Codan or a Codan-authorised supplier.
0191 0191
To Next Page
Loading...
Need help?
General
