NGT—Channel additions
134 NGT Transceiver System Technical Service Manual
Programming channels
Creating a channel
This section covers creating a channel in a transceiver in which receive and transmit
frequencies can be entered.
To create a channel:
1 Press until Main Menu is displayed.
1 Select Channel.
The currently selected channel is displayed. For example:
1 Hold to open the List Manager.
1 Select Create entry.
The transceiver suggests a name for the new channel based on the name of the
channel you were on.
NOTE
If you are operating the transceiver in a country that has stringent
licensing regulations, you may not be permitted to create channels with
transmit frequencies.
If the TxD option has been installed in the transceiver there are
restrictions on the frequencies you can enter. Use page 137, Creating a
channel with the TxD option.
If the TxP option has been installed in the transceiver you cannot create
channels.
NOTE If the Channel List is empty, Free Tune is displayed.
NOTE
If the Channel List is empty a name is not displayed. Enter a name for
the channel.
To Next Page
Loading...
Need help?
General
