CodaOctopus F175 MOTION - Page 11

Connection Details
Copyright © 2013 Coda Octopus Products Ltd
11
F175 MOTION Sensor - Trimble SPS361/SPS461 Integration
Item
Connector Type
Description
3
TNC
Connect to GNSS antenna 2 for vector and heading. When
connected to a GA530 antenna, it will provide MSK Beacon
signal.
NOTE: Marinestar is not supported on this antenna port.
4
High Density DB26
Ethernet with PoE connectivity to a 10/100 Base-T network
through an RJ45 jack on a multiport adaptor or cable
Primary power from a Trimble AC/DC power supply (P/N
51695) using the multiport adaptor or cable
Full 9-wire RS-232 serial communications using the 26-9-pin
multiport adaptor or a 26-pin serial communications cable
1PPS, 2 x RS-232, input DC, Ethernet cable
5
Vent plug
External venting plug for pressure equalization