Camera and wiring is installed into the male 1 ½ NPT.
2.1 Locate and install the three ½ x 1-inch hex Allen screws from
the inside of the mounting ring. Be sure the Allen screws do not
extend beyond the outside of the ring.
2.2 Install the camera mount on top of the unit. Rotate to
desired position.
2.3 Verify camera mount is evenly positioned to ensure gasket seal
is seated appropriately 360 degrees.
4.1 Remove the clear Lexan dome from the black metal casting.
4.2 The casting, complete with strobe, should be brought to the
top of the unit (Overhead Camera Mount) where the wiring will be
connected (see wiring instructions).
4.3 After the wiring is complete, set the casting on top of the unit
and fasten the casting to the Overhead Camera Mount by reach-
ing through the casting openings and tightening the three 10-24 X
1-inch stainless steel thumbscrews against the inner wall.
4.4 Finally, reattach the clear Lexan dome to the black metal cast-
ing with the security screws provided.
The three Allen screws MUST be used to secure the Overhead
Camera Mount to the unit.
SKIP if installation does not include an Overhead Camera
Mount accessory.
NOTE: If retrofitting existing unit with three countersunk holes near
the top of the bollard, the Overhead Camera Mount may be rotated
to align the clearance holes with holes in the unit. The three
counter- sunk screws and nuts provided may be used to cover
these holes.
CB Unit
Gasket Seal
LED Area Light
Dome Metal
Casting
Lexan Dome
Top
Overhead Camera Mount Accessory
3.0
3.1
4.0
TOOLS REQUIRED
INSTALL CAMERA
INSTALL THE DOME TOP ASSEMBLY
1.0 RETRO-FITTING EXISTING UNIT
1.1 If applicable, remove dome top assembly prior to installation.
New style dome top assembly is required to access installation
screws on Overhead Camera Mount.
2.0 INSTALL CAMERA MOUNT
6
1
2
3
5
4
Overhead
Camera Mount
Access Panel
Security Bit
7/16
Wrench
Allen
Wrench
Ladder
CB 1 Series
Administrator Guide
GU-157-FF
4
2.4 Apply downward pressure while simultaneously tightening the
three 1/2" set screws until snug against the inside of the pedestal.
page 12 of 31
Code Blue
• 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com
To Next Page
Loading...
