Code Blue ● 259 Hedcor Street ● Holland, MI ● 4923 USA ● 800.205.7186 ● www.codeblue.com Rev 6/2021 page 45 of 57 GU-164-A
Other Settings
Refer to Section 6 to complete the setup of the LS1000, including Numbers, General Settings, Hardware
Settings and Action Scripts. When finished, it should now register to CUCM and be able to place calls in
the assigned calling search space as well as receive calls at the directory number it is configured with.
Note: If you are setting up the LS1000 with secondary account support, make sure that you create
each failover number twice.
4. UCM CONFIGURATION
All UCM-side configuration is done within the Cisco Unified CM Administration web interface.
5. Create Phone Security Profile
1. Navigate to System > Security > Phone Security Profile.
2. Do a Find on “Third-party” to locate the Third-party SIP Device Basic - Standard SIP Non-
Secure Profile. Click the Copy icon.
3. Check Enable Digest Authentication.
4. Change the Name and Description to Code Blue LS1000 Profile.
5. Click Save.
6. Configure End Users
For each LS1000 device, configure a new end user for SIP authentication.
1. Navigate to User Management > End User.
2. Click Add New.
3. For the User ID, enter the Directory Number of the LS1000 phone.
4. Fill in the Last Name field with the Directory Number.
a. The Directory Number, User ID, and Last Name fields must all be the same.
Create and record a secure SIP password and fill in the Digest Credentials and Confirm Digest Credentials
fields with this password. You will be entering this password later into the LS1000.
5. Click Save.
To Next Page
Loading...
