Code CR900FD - Page 59

4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 59 of 106
© 2013-2016 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  (801) 495-2200  FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
C9
Interleaved 2 Of 5
Lengths
0
Valid Range: 0 to 64 (#100)
The number of digits allowed in an Interleaved 2 of 5 barcode,
plus indicating support for a small quiet zone.
The length allowed is always even. If an Interleaved 2 of 5 has
a smaller/shorter than standard quiet zone, 1 can be added to
the length to tolerate the issue (but also increase the chance of
partially decoding the barcode). Max value for C9 is 100 (100
digits without support for small quiet zones).
Examples:
To set length to 8, and
 To enable small quiet zone, set C9 to 9 (8 + 1)
 To disable small quiet zone, set C9 to 8 (8 + 0)
To set length to E (#14), and
 To enable small quiet zone, set C9 to F (#15) (E + 1)
 To disable small quiet zone, set C9 to E (#14) (E + 0)
Bit
Controls
Value
0
Small Quiet Zone
0: Disabled
1: Enabled
[6:1]
Number of Digits (Must be even and 64 (#100)
or less)
[31:7]
Reserved
Keywords: #2Of5, #Interleaved2Of5
CA
Auto Disconnect
0
0: Retain connection until explicit disconnect command
1: Disconnect from the Host when there is nothing to send. (In
conjunction with registers C6 and 73, the Reader will
connect when there is data to send, send the data, then
disconnect (to allow another Reader to connect to the same
Host).
2: Retain connection until reader enters sleep mode.
Disconnect from the Host when the reader enters sleep
mode.
Note: Only applies to readers using Bluetooth® communication
modes.