Code CR900FD User Manual

4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 90 of 106
© 2013-2016 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  (801) 495-2200  FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
2CA
Extended Duplicate
Block Time Options
1
Binary Dip Switch
Bit
Controls
Value
0
Use extended duplicate block time if
stand is detected
0: Disabled
1: Enabled
1
Use extended duplicate block time if
in motion detection mode
0: Disabled
1: Enabled
2
Use extended duplicate block time if
in continuous scan mode
0: Disabled
1: Enabled
3
Always use extended duplicate block
time
0: Disabled
1: Enabled
Keywords: #DuplicateBlock, #Stand
2CB
iPhone Onscreen
Keyboard Release
Delay (ms)
7D0
(#2000)
Valid Range: 0 to 7FFFFFFF (#2147483647) Milliseconds
When the iPhone receives keyboard data from the sled, the
onscreen keyboard will disappear before sending the first
character, and reappear after receiving the last character. This
setting is the number of milliseconds that the onscreen
keyboard will remain hidden after receiving the last character
from the sled.
Note: Supported on CR4405 only.
2CC
Allow sending USB
scancodes over a
Bluetooth® SPP
connection
1
0: Disabled
1: Enabled
If Enabled, the reader will send data as USB scancodes to a
modem that requests this behavior, instead of sending just the
decoded bytes. If Disabled, or if the modem does not request
USB scancodes, the reader will send the data as the decoded
bytes.
Note: Supported on Bluetooth® readers only.

Code CR900FD Specifications

General

Brand	Code
Model	CR900FD
Category	Barcode Reader
Language	English