Code CR900FD User Manual

4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 96 of 106
© 2013-2016 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  (801) 495-2200  FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
2E7
Maximum In-Stand
Brightness Percent
3C
(#60)
Valid Range: 0 to 64 (#100) Percent
The percentage of maximum illumination of the red LED under
certain conditions.
Maximum In-Stand Brightness Percent applies when the reader
is 'In-Stand' but only for images with settings optimized for
barcodes printed on paper and not images with settings
optimized for barcodes displayed on cellphone screens. For
more information on when the CR5000 & CR5000RTC uses
those settings, see Cellphone Settings (231).
Note: Applies to CR5000 & CR5000RTC readers only.
Keywords: #Stand, #StandModes
2F0
Output Encoding of
Unicode converted
input
0
This setting determines output encoding of decoded data that
was previously converted to Unicode code points. This register
is ignored if no conversion was made.
Value
Description
0
Send Unicode data using Keyboard XML lookup
Keywords: #KeyboardMap
1
Send Unicode data using Alt-Sequences
Note: Applies to HID Keyboard modes only.
Keywords: #DataEncoding
2F1
Output Good Read on
RTS
0
Controls whether the Serial Flow Control RTS line should be
used to output a Good Read signal.
The pulse width of this signal is controlled by setting 0x01EA.
Bit
Controls
Value
0
Enable Output of Good Read on
RTS
0: Disabled
1: Enabled
1
Good Read RTS Polarity
0: RTS Active
Low on Good
Read
1: RTS Active
High on Good
Read
Note: Undefined behavior will result if this setting is enabled
when Serial Flow Control (0x1F) is enabled.
Keywords: #GoodReadRTS

Code CR900FD Specifications

General

Brand	Code
Model	CR900FD
Category	Barcode Reader
Language	English