Before closing the door, enter the code and check that
the latchbolt retracts when the lever handle is depressed.
Now check the operation of the inside lever handle. If there
is any binding of the handles or latch then loosen the top
and bottom bolts and reposition the plates slightly until
the correct position is found, and then re-tighten the bolts.
Cut one of the long socket head screws to the required
length for your door. Approximate overall length should
be door thickness plus 25mm (1”), to allow about 10mm
(
3
/
8
”) of threaded bolt to enter the front plate. Place the
neoprene gasket over the adaptor plate. Use the screw
with the ‘T’ shaped Allen key, to fix the back plate to the
front plate through the TOP hole. Using the 20mm (
13
/
16
”)
socket head screw fix the back plate through the BOTTOM
hole to the adaptor plate. Do not use excessive force.
STEP 5
STEP 6
Take the adaptor kit, item 13 on the contents page.
Cut the two M5 countersunk head bolts to length to suit
the door thickness; i.e. door thickness plus a maximum
of 10mm (
3
/
8
”) - no more than 5mm (
3
/
16
”) should enter
the front plate. Hold the front plate, with the three hole
neoprene seal, against the door over the protruding
spindle. From the other side of the door, fix the adaptor
plate to the front plate using the two M5 countersunk
bolts. Before tightening up the fixings, make sure that
the spindle hole is centrally positioned over the follower.
Do not use excessive force.
STEP 4
To Next Page
