Section 2 - CL510/CL515
Fix the latch with the wood screws, with the bevel towards
the door frame.
Fitting the strike plate. NB: The plunger beside the
latchbolt deadlocks it, to protect against manipulation
or ‘shimming’. The strike plate must be accurately
installed so that the plunger CANNOT enter the aperture
when the door is closed, even if it is slammed shut.
Position the strike plate on the door frame so that it lines
up with the flat of the latchbolt, and NOT the plunger.
Mark the positions of the fixing screws, and draw around
the aperture of the strike plate. Chisel out the aperture
15mm (
5
/
8
”) deep to receive the latchbolt. Fix the strike
plate to the surface of the frame using only the top fixing
screw. Gently close the door and check that the latchbolt
enters the aperture easily, and is held without too much
‘play’. When satisfied, draw around the outline of the
strike plate, remove it and cut a rebate to enable the
faceplate to lie flush with the surface. Re-fix the strike
plate using both screws.
Check that the lever handles are correctly orientated for
the hand of door. To change the hand of a lever handle
see Section 1A, Step 3 (CL500/CL505). N/A for CL500
KEY models.
STEP 5
STEP 6
STEP 7
STEP 8
For door hung on RIGHT fit silver spindle
on code side.
For door hung on LEFT fit coloured spindle
on code side.
Fit the butterfly spindle to the inside,
non-code side.
To Next Page
