CODELOCKS CL5500 - Factory Reset

24/9/2561 KA-01040 · Customer Self-Service
https://support.codelocks.com/knowledgebase/article/KA-01040/en-us 2/13
Remote Release
The lock has two sets of terminals within the front housingfor remote release, labelled REM1 and REM2.
REM1 is intended for push-button release where the lock will open for the normal set time. REM2 is
intended for use where the lock needs to be released for a longer period. When a switch or relay
connected to REM2 is closed, the lock will open for a period of 30 minutes after which the lock will revert
to normal operation. Refer to Installation Instructions for further information.


The App
Manage with the K3 Connect App
The lock can be managed with the K3 Connect App by any Bluetooth compatible smartphone.
The Appis available on:
Apple App Store for Apple devices or Google Play™ for Android™ devices by searching forK3 Connect.
1. Install the K3 Connect App on your device.
2. Once installed, open K3 Connect and selectCreate Account.
3. The account creation process includes email confirmation. Once the account has been created, sign-
in to the App.
4. To add a new lock, touch the+iconon theLocksscreen.
5. Enter the lock DIN and choose a lock name.
For this lock range it is CL5510 - DIN: CL5510
Note:The lock DIN is case-sensitive. DIN to be used for all CL5500 variants i.e. CL5510, CL5520,
CL5500PK etc.
6. In the App, touch the tickand then immediately, on the lock, enter the following Program:
#Master Code•00•1••
Example:#12345678•00•1••
Note:If you have changed your Master Code, substitute the code used in the example with your own
code.
7. The lock will now pair with your phone.

Factory Reset
The lock can be reset to its original factory settings. You may need to do this if the Master Code is no
longer known or you no longer have management access via a smartphone. To reset the lock, you must
have access to the battery compartment in the rear of the lock.
1. Remove a battery.
2. Press and hold the0button.