COE S7 - Daily Operation

Operation
10
Daily operation
FLUID LEVELS
PRIOR to starting CHECK all vital fluid levels. And FILL as necessary.
 ENIGNE OIL Pull dip stick and check to make sure oil is in proper operating
range.
Add High Quality Low Sulfur Motor Oil (15-40W ) as needed.
 HYDRAULIC FLUID Check site glass for fluid level ( Fluid level will be indicat-
ed by a dark brown/black color ). If there is no fluid showing in site glass fill with a
Quality
15-40W motor oil TO CENTER OF SITE GAUGE.
 RADIATOR COOLANT Check coolant level recovery tank daily. Fill with 50/50
mixture of water and coolant as needed. Tank has Cold & Hot indicators.
 LTR RADIATOR CIRCUIT Keep LTR tank filled with 50/50 mixture of water and
coolant to within 1” of tank top.
 DIESEL FUEL Fill fuel reservoir at the end of each work day with a FILTERED
high quality OFF ROAD diesel fuel. ( DO NOT SMOKE WHILE REFUELING )
 SLING INJECTION SYSTEM Fill reservoir daily or more often if necessary with
filtered water and 8 to 16 ounces COE SLING LUBE. Use 16 ounces of COE
SLING LUBE for 2 days after installing new slings or flaps. ( DO NOT USE ANY
TYPE OF SOAP IN LIEU OF COE SLING LUBE, EXCESSIVE BARKING WILL
SHAKER BODY
PRIOR to starting PERFORM these simple procedures .
 LUBRICATION Grease ALL points as per schedule and chart in the SERVICE
section of this manual USING only a high quality lubricating grease.
 INSPECTION Visually inspect the shaker frame, components, tires, hoses and
connectors and all other items for cracks, wear, loose items, leaks and
malfunctions. Make necessary repair(s) before operating equipment.
 CLEAN Keep machine body and interior compartments clean of debris, trash
and leaking fluids. ( BUILD UP OF ITEMS CAN CAUSE FIRES )
 AIR CLEANER Service air cleaner DAILY or MORE OFTEN in severe dust
conditions. Consult SERVICE section for proper air cleaner cleaning method.
 COOLING SYSTEMS Clean engine radiator, oil cooler, AC condenser, LTR ra-
diator and intake screen DAILY or MORE OFTEN in SEVERE debris environments.
( FAUILURE TO CLEAN COOLING SYSTEM CAN CAUSE SEVERE DAMAGE)
 SHAKER HEAD Check belt for proper tension and for wear. Inspect suspen-
sion for worn mounts or loose bolts. Check all pins and bolts. Inspect pads and
slings and flaps. ( REPLACE ITEMS AS NECCESARY TO PREVENT BARKING
DAMAGE )