COE S7 - Page 18

BELT AND TENSIONER
 BELT Check belt regularly for tension
and wear. Make adjustments as necessary.
 TENSIONER Check belt tension hourly
when new and daily during inspection.
Service
15
CAGE MOUNTS
 CAGE Regularly check cage
frame for wear or cracks.
 RUBBER MOUNTS Replace
hanger mounts if cracked or
deformed.
 BOLT & NUT Make sure nuts
are not loose or that bolts are
not bent.
 WASHER Top and lower
washers may wear check regu-
larly.
 TIGHTEN Nuts and bolts after
initial use. Loose mounts will
cause excessive swinging of
the head.
BELT AND TENSIONER
 BELT Check belt regularly for tension
and wear. Make adjustments as necessary.
 TENSIONER Check belt tension hourly
when new and daily during inspection.
ENERGY WHEEL COMPONENTS
 BEARINGS Inspect bearings regularly for excessive play.
This may be a indication of failing bearings. Replace as neces-
sary. Grease energy wheel bearing every 50 hours of use or
more often if needed. Only use COE grease or warranty is void.
 WEIGHTS Periodically check weight bolt torque. Loose
bolts can shear causing damage.
 MAIN BOLT Periodically check energy pin bolt torque. If
bolt becomes loose damage will occur.
SHAKER HEAD HOSES
 HOSES check hoses regularly for
wear or leaks. Tree limbs can also
fall and damage or break hoses. Re-
place or adjust as necessary.