Regulations/Conformity:3D-A5000 Sensors
Note: For the most current CE declaration and regulatory conformity information, see the Cognex support site:
cognex.com/support.
Cognex 3D-A5000 series sensors meet or exceed the requirements of all applicable standards organizations for safe
operation. As with any electrical equipment, however, the best way to ensure safe operation is to operate them according
to the agency guidelines that follow. Please read these guidelines carefully before using your device.
Safety and Regulatory
Manufacturer Cognex Corporation 1 Vision Drive Natick, MA 01760 USA
Canada ICES-003, Class A
European Community
This equipment complies with the essential requirements of the EU
Directive 2014/30/EU. Declarations are available from your local
representative.
3D-A5005; Regulatory Model R00094
3D-A5030; Regulatory Model R00095
3D-A5060; Regulatory Model R00092
FCC Class A Compliance Statement This equipment has been tested and found to comply with the limits for
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
KCC 3D-A5005: Regulatory Model R00094 R-R-CGX-R00094
3D-A5030: Regulatory Model R00095 R-R-CGX-R00095
3D-A5060: Regulatory Model R00092 R-R-CGX-R00092
NRTL TÜV SÜD AM SCC/NRTL OSHA Scheme for UL/CAN 61010-1
CB TÜV SÜD AM, IEC/EN 61010-1. CB report available upon request
RoHs Compliant to the most recent applicable directive.
17
Regulations/Conformity:3D-A5000 Sensors
To Next Page
Loading...
Need help?
General
