EN
60
cod. 3542C090 - Rev. 01 - 09/2022
CADI
2.3 Assembling the heater
Before assembling the heater,
make sure the water and gas
connections are properly secu-
red, identied, and positioned.
See the dimensions and con-
nections in section 4.2.
• Fix the plugs and hooks on the wall, in a central po-
sition vertical to the appliance, as shown in the gure
below.
• Mark the position of the bottom screws
• Hang the water heater on the plugs+hooks and tighten
the screws for xing the unit to the wall.
• Connect the hot and cold water exible tubes, remem-
bering to check their tightness. To avoid circulation pro-
blems, do not remove the cold water inlet lter.
g. 6 - Dima di montaggio
To Next Page
Loading...
