PART
I
CLEANING PROCEDURES
Cleaning and sanitizing schedules are governed by your State
or local regulatory agencies and must be followed accordingly.
A
well planned cleaning schedule will eliminate excessive
waste of time and product within your organization.
3)
Place
a
container or bucket under the spigot head. Slowly
pull the handle down and remove remaining product from
the cylinder.
On a designated day(s) of the week, allow the mix in the mix
tank to run as low as feasible.
Proceed to clean the machine, as follows:
1)
Remove the Gravity Feed Tubes. Pull the tubes straight up
and out.
4)
When the product has stopped flowing, turn the Selector
Switch to the
OFF
position. Close the spigot handle.
2)
Turn the Selector Switch to
BEATER
position and let the
machine run for
4
to
5
minutes. This will soften the product
in the cylinder and allow the remaining product to be removed
more easily.
To Next Page
Loading...
