5) Fill hopper@) and cylinder(s) with cold water (a mild, non-
foaming dish washing detergent is recommended).
6)
Turn Selector Switch to the BEATER position for one minute.
Turn Selector Switch to OFF position, drain water by opening
the spigot handle. Repeat this process until water is clear.
IMPORTANT: Operate unit only in the BEATER position when
cleaning. Do not operate unit for excessive periods in the
BEATER position, one minute intervals per rinse is recommended.
7)
Brush all surface areas, with brushes provided, to remove all
mix particles.
8)
Drain Water:
9)
The Gravity Tubes must now be disassembled. To disassemble,
first remove the "SPLASH GUARD" by pulling it out of the tube.
To Next Page
Loading...
