What to do if my Coldelite Freezer has no power?
If your Coldelite Freezer has no power, first check the plug, disconnect switch, and fuses. Also, try pushing the reset button. Ensure the spigot head is properly assembled. If the reset trips, wait for it to cool down before pushing it again.
Why is my Coldelite UC 511 G going off on high pressure?
Your Coldelite Freezer might be going off on high pressure because the condenser needs cleaning (for air-cooled models). Another possible cause is a malfunctioning Klixon on the compressor. You should also check the water flow.
What to do if the Coldelite Freezer is drawing faster than machine can produce?
If your Coldelite Freezer is drawing faster than the machine can produce, slow down the draw rate.
What to do if there is restricted air flow in Coldelite UC 511 G?
If you notice restricted airflow in your Coldelite Freezer, the first step is to remove any obstructions or restrictions that you can identify.
What to do if there is no mix or low mix in the mix tank of my Coldelite Freezer?
If there's no mix or low mix in the mix tank of your Coldelite Freezer, add mix to the mix tank. Also, adjust the gravity feed tube sleeve to a larger opening.
What to do if the cylinder temperature is too cold in my Coldelite Freezer?
If the cylinder temperature in your Coldelite Freezer is too cold, check the mix in the hopper and add more mix if needed. Also, ensure there is enough mix in the cylinder by opening the gravity feed valve.
Why is the ice cream too hard in my Coldelite UC 511 G?
If the ice cream from your Coldelite Freezer is too hard, check the temperature and amperage. If the temperature is too low or the amperage is too high, recalibrate the value of HOM. Ensure there is enough mix in the cylinder by opening the gravity feed valve.
What to do if O-ring is missing or has a split in my Coldelite UC 511 G Freezer?
If the O-ring is missing or has a split in your Coldelite Freezer, install or replace the O-ring. You can also try tightening the hand knob.
What to do if there is a defective O-ring in my Coldelite UC 511 G?
If you find a defective O-ring in your Coldelite Freezer, replace any worn or damaged O-ring. Additionally, close the liquid hole in the feeding tube, draw several portions, and then reopen the hole.
What to do if the Eprom is out of order in my Coldelite Freezer?
If the Eprom in your Coldelite Freezer is out of order, first check if it is properly fixed. If not, replace the Eprom.
Guidelines for placing the freezer in its operational location, including clearance and leveling.
Details on power supply, wiring, grounding, and fuse requirements for safe operation.
Details on the digital display, buttons, and indicators on the control panel.
Information about the internal electric control panel and safety precautions.
Covers various other control components like solenoid valves and pressure cut-outs.
Instructions for reassembling the beater and auger components.
Detailed steps for putting together the dispensing head assembly.
Key maintenance tasks including O-ring care, cleaning, lubrication, and part replacement.
To Next Page
General
