Need help?Do you have a question about the Coldelite UF-253G and is the answer not in the manual?
Procedures for unpacking the machine and checking for shipping damage.
Guidelines for selecting an ideal location and positioning the freezer.
Instructions for connecting water-cooled condensers to water supply and drain.
Requirements for air circulation around air-cooled condensers for optimal performance.
How to adjust the water valve for proper head pressure control.
Details on wiring standards, power supply, and voltage requirements.
Checking the correct clockwise rotation of the beater motor after installation.
Explanation of the selector switch, indicator lights, and reset button.
Explanation of front/rear micro switches, thermostats, and level switches.
Disassembly, washing, and rinsing of parts with specific instructions.
Detailed instructions for correctly reassembling the freezer parts.
Procedure to retard bacteria growth and ensure product safety.
Step-by-step instructions for cleaning and sanitizing as per NSF standards.
Procedures for loading mix and initial machine operation.
How to draw the ice cream product from the machine.
Specifications for the compressor, cooling system, and refrigerant.
Data on beater motor, HOM cut-out amperage, and drive belts.
Explanation of the Hard-O-Matic system for product consistency control.
Steps to calibrate the rear micro switch for proper product firmness.
Guidelines for maintaining and replacing Hard-O-Matic springs.
How to adjust the thermostat for the mix tank temperature control.
Usage and calibration of the energy conservation feature for economy.
How micro switches activate beater motors during dispensing.
Procedure for calibrating front micro switches for correct beater engagement.
Essential maintenance tasks to ensure longevity and performance.
Critical safety precautions to follow when performing maintenance.
Common causes and remedies for loss of pressure in the freezing cylinder.
Troubleshooting steps for when the beater/auger fails to rotate.
Diagnosing and fixing issues related to soft product consistency.
Common problems and solutions for the mix pump not working.
Addressing issues where no product dispenses from the spigot.
Troubleshooting steps for when the machine fails to freeze.
Identifying causes for the machine running continuously.
Solutions for a mix tank that is too warm.
Diagnosing and resolving banging noises originating from the rear of the machine.
Troubleshooting when the beater motor fails to stop.
Steps to resolve issues preventing the machine from starting in AUTO mode.
Causes and solutions for excessive foam formation in the mix tank.
Troubleshooting short cycling problems on the machine.
Identifying and fixing causes of mix dripping from rear drip chutes.
Addressing the problem of the machine smoking and its potential causes.
Troubleshooting mix drips from the rear of the head assembly.
Diagnosing and resolving problems related to low product overrun.
To Next Page
General
