3
Index
Foreword Page #
Part I Installation
A) Uncrating 4
B) Positioning the Machine 4-5
C) Electrical Requirements 5
D) Completing the Installation 5
Part II Explanation of Controls
A) Electronic Control Panel 6
B) Dispensing Handles 7
C) Proximity Switches 7
D) Dispensing Head Safety Switch 7
E) Electric Control Panel 7-8
F) Other Controls 8
Part III Initial Cleaning Procedure
A) Gravity Fed Cleaning Procedure 9
B) Pump Fed Cleaning Procedure 10
C) Disassembling the Dispensing Head 11
D) Disassembling the Beaters / Augers 12
E) Cleaning Operations 12
Part IV Assembling the Freezer
A) Assembling the Beaters / Augers 13-14
B) Assembling the Dispensing Head 14-16
C) Assembling the Gravity Feed Tubes 16-17
D) Assembling the Mix Injection Pumps 17-18
Part V Sanitizing the Freezer 19-20
Part VI Starting the Freezer
A) Gravity Fed Machines 21
B) Pump Fed Machines 22
Part VII Operating the Freezer
A) Stand By Mode 23
B) Gravity Fed Machines – How to Operate and Make Adjustments 24
C) Pump Fed Machines – How to Operate and Make Adjustments 24
Part VIII Periodic Cleaning Procedures
A) Gravity Fed Machines 25-26
B) Pump Fed Machines 26-28
Part IX Technical Information
A) Refrigeration 28
B) Beater Drive Motor 28
C) Thermal Overload 28
D) Proximity Switches 28
Part X Maintenance
A) Troubleshooting Guide 29-31
To Next Page
Loading...
