Connect Frame to Tent
– Insert one end of main tent pole onto
pin of ring and pin system, at tent
corner. (illus. 3)
– Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pin into the pole.
– Repeat for second pole. (illus. 4)
CEDAR PASS
TM
DOME
1
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door
facing desired direction. (illus. 1)
– Unzip door.
– Stake down tent corners only, using the
stake loops. (illus. 2) Keep the floor taut.
– Assemble Frame Poles by interlocking
shock-corded poles.
– Insert the poles into Pole Sleeves.
The poles should cross forming
an “X” in the middle of tent. (illus. 1)
2
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
– Do not set up your tent under trees.
– For best results in windy conditions,
position the end of tent into the wind.
(1) Rainfly
Pole
Rainfly Part No. 9160-306
(2) Main Tent
Poles
POLE ASSEMBLY PARTS
Instructions apply to Part Number 9160-908
illus. 4
Tent frame
set-up
Part No. 9160-302
Part No. 9160-304
illus. 3
Insert pin into pole end
Assembled
poles
inserted
through
pole
sleeves
illus. 1
illus. 2 Tent stake through ring
To Next Page
Need help?
General