Coleman CRESTLINE 9277E107 User Manual

Connect Frame to Tent
– Insert one pin into the end of main tent
pole at tent corner. (illus. 3, illus. 4)
– Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pin into the pole end.
– Repeat for second pole.
– Insert pin into the end of side pole, go to
opposite end of pole and apply pressure
until you arch the pole and can insert
the pin into the pole. (illus. 3, illus. 4)
– Repeat for other side pole.
CRESTLINE
™
9’10”x7’
1
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door
facing desired direction. (illus. 1)
– Unzip door.
– Stake down tent corners only, using the
stake loops. Keep the floor taut.
(Intermediate loops will be staked later.)
– Assemble frame poles by interlocking
shock-corded poles. (four poles)
– Insert the poles into pole sleeves.The
longer black poles should cross forming
an “X” in the middle of tent. The shorter
side grey poles insert into sleeves
running front to back. (illus. 1)
2
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard
or sharp objects.
– Do not set up your tent under trees.
– For best results in windy conditions,
position the end of tent into the wind.
(2) Rainfly Poles
Side poles
(Grey)
Assembled
poles
inserted
through
pole
sleeves
Instructions apply to Part Number 9277E107
illus. 1
illus. 2
Tent stake
through ring
on stake loop
illus. 4
Tent frame
set-up
Part No. 9277E102
Part No. 9277E103
Part No. 9277E104
illus. 3
Insert pin into pole end
Rainfly Part No.
9277E105
(2) Main Tent Poles
(Black)
(2) Side Poles
(Grey)
POLE ASSEMBLY PARTS

Coleman CRESTLINE 9277E107 Specifications

General

Seasons	3-season
Doors	1
Frame Material	Fiberglass
Floor Material	Polyethylene
Material	Polyester

Summary

Tent Setup Preparation

Layout and Pole Assembly

Position Tent and Stake Corners

Lay out tent, unzip door, stake corners, and keep floor taut.

Assemble and Insert Tent Poles

Interlock shock-corded poles and insert into sleeves, forming an X with main poles.

Connect Tent Frame

Attach Poles to Tent Corners

Insert pins into tent corners and apply pressure to arch poles into place.

Attach Tent to Frame Using Frame Clips

Secure Tent Frame with Clips

Attach frame clips along tent edges to poles and stake intermediate loops.

Attach Rainfly

Assemble and Connect Rainfly

Insert rainfly poles, drape rainfly, connect loops with S-hooks, and secure.

Important Tent Information

Tent Care and Safety Advice

Covers condensation, storage, stake removal, pole storage, seam sealing, and sun exposure.