Coleman PEBBLE CREEK 9272A210C User Manual

Connect Frame to Tent
– Insert one pin into the end of main black tent
pole to the side of the door. (illus. 3), (illus. 4)
– Go to opposite end of pole and gradually
apply pressure to the pole forming an arch
until you are able to insert the pin into the
pole end.
– Repeat for second pole.
– Insert remaining pin into the end of side pole,
go to opposite end of pole and apply
pressure until you arch the pole and can
insert the pin into the pole. (illus. 3), (illus. 4)
– Repeat for other side pole.
COLEMAN
®
PEBBLE CREEK
TM
1
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with doors
facing desired direction. (illus. 1)
– Unzip doors.
– Stake down tent corners, using the stake
loops. Keep the floor taut. (illus. 2)
– Stake down tent through the rings on the pin
and ring system.
– Assemble frame poles by interlocking shock-
corded poles. (four poles)
– Insert the poles into pole sleeves. The longer
black poles should cross forming an “X” in
the middle of tent. The shorter side grey
poles insert into sleeves running front to
back. The shorter black center pole runs
straight front to back. (illus. 1)
2
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard
or sharp objects.
– Do not set up your tent under trees.
– For best results in windy conditions,
position the end of tent into the wind.
(2) Rainfly Poles
Side poles
(Grey)
Short Center
Pole (Black)
Assembled poles inserted
through pole sleeves
Instructions apply to Part Number 9272A210C
illus. 1
illus. 2
Tent stake
through ring
on stake loop
illus. 4
Tent frame
set-up
Part No. 9272A321
1
Part No. 9272A3231
Part No. 9272A3251
Part No. 9272A3151
illus. 3
Insert pin into pole end
Rainfly
(2) Main T
ent Poles
(Black)
(2) Side Poles (Grey)
Part No. 9272A3191
Part No. 9272A3171
(1) Center Pole
(Black)
(2) Upright Poles
(Black)
POLE ASSEMBLY PARTS

Coleman PEBBLE CREEK 9272A210C Specifications

General

Tent Fabric	Polyester
Floor Fabric	Polyethylene
Pole Material	Fiberglass
Doors	1
Rainfly	Yes

Summary

Tent Setup Preparation and Initial Layout

Choosing a Campsite

Select a level campsite clear of rocks, branches, and other hard or sharp objects. Avoid setting up under trees.

Tent Layout and Pole Assembly

Position tent with doors facing desired direction, unzip doors, and stake down tent corners and rings.

Connecting Tent Frame Poles

Assemble frame poles by interlocking shock-corded poles and insert into sleeves, forming an 'X' with black poles.

Attaching Tent Components

Attaching Center and Upright Poles

Insert center pole ends into hub top, and upright pole ends into hub bottom, securing with metal clips.

Attaching Frame Clips and Rainfly

Attach frame clips to tent edges, insert rainfly poles into sleeves, drape rainfly, and hook elastic loops.

Important Information and Warnings

Condensation and Ventilation

Condensation can form due to humidity and breath; minimize by removing wet clothing and ensuring ventilation.

Tent Storage and Maintenance

Dry tent thoroughly before storage, do not pack stakes/poles inside, and do not store poles telescoped.

Flame and Heat Source Warning

Keep flame and heat sources away from tent fabric; it meets flammability requirements but will burn if exposed.