Coleman Peak 1 9805-230 User Manual

Connect Frame to Tent
– Insert one Pole Tip into the grommet on the
webbing located at the corners of the tent (illus. 4).
– Go to opposite end of the same pole and
gradually apply pressure to the pole, forming an
arch, until you are able to insert the pole tip
into the grommet
– Attach the two Frame Clips at
the mesh vent to the pole
– Repeat for second pole
1
2
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door facing
desired direction. (illus. 1)
– For best results in windy conditions, postion
door or back of tent into the wind.
– Unzip door.
– Stake down tent corners. Keep the floor
taut.(illus. 2)
– Assemble Frame Poles by interlocking the
shock-corded sections. This will make two
long poles.
– Lay the poles out diagonally, centered on the
tent.The center of the poles should cross
forming an “X” in the middle of tent. (illus. 1)
– Fasten Toggle & Loop on top of tent over both
poles. (illus. 1), (illus. 3)
illus. 1
Toggle & Loop
illus. 2
Tent stake
through Loop
illus.4
Insert Pole Tip on
stake loop into pole.
illus. 5 Tent frame set-up
illus. 3
Toggle &
Loop
POLE ASSEMBLY PARTS
illus. 6
Frame Clips
aries
™
2
part number 9805-230
Main Tent Poles (2)
Part No. 9805-1101
Rainfly
Part No. 9805-1151

Coleman Peak 1 9805-230 Specifications

General

Brand	Coleman
Model	Peak 1 9805-230
Category	Tent
Type	Backpacking
Capacity	2-person
Setup Time	10 minutes
Doors	1
Rainfly	Yes
Floor Area	31.5 sq ft
Peak Height	3 ft

Summary

Layout & Positioning of Tent, Pole Assembly

Position Tent and Door

Position the tent with the door facing the desired direction, ideally into the wind.

Stake Tent Corners

Stake down all tent corners, ensuring the floor remains taut for stability.

Assemble Tent Poles

Assemble the two long main tent poles by interlocking their shock-corded sections.

Position Poles and Secure Top

Lay poles diagonally to form an 'X', crossing in the center, then secure with Toggle & Loop.

Connect Frame to Tent

Insert Pole Tips into Grommets

Insert one pole tip into the grommet at a tent corner, then apply pressure to insert the other end.

Attach Frame Clips

Attach the two Frame Clips located at the mesh vent to the assembled tent pole.

Attach Tent to Frame Using Frame Clips

Secure Tent with Frame Clips

Attach the remaining frame clips along the tent edges to the frame poles for a secure fit.

Adjust Tent Stakes

Make any necessary adjustments to the tent corner stakes for optimal tension and stability.

Attach Rainfly

Drape and Orient Rainfly

Drape the rainfly over the tent frame, ensuring zippers are out over the front door.

Secure Rainfly with Velcro and Clips

Secure the rainfly using underside velcro ties and connecting the corner clips to the tent.

Secure Guy Lines

Extend and stake out the guy lines tautly to provide additional stability and wind resistance.