EasyManuals Logo

Coleman CT200U User Manual

Coleman CT200U
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
OIL AND FUEL
Engine Oil
Mini bike may have oil in it when
shipped from the factory.
However, it is a good idea to
drain this oil and replace with
new SAE 10W-30 Motor Oil.
1
Changing the engine oil
1. Remove the oil ll plug (1)
2. Remove the drain bolt (2) located on
the bottom of the engine.
3. Allow the oil to drain in an appropriate
container. Note: Dispose of oil at an oil
recycle center.
4. Install the drain plug and ll with SAE
10W-30 motor oil. This mini bike takes
.63qt. (.6L) of engine oil. Oil should be up
to the brim of the ll hole.
5. Re- install ll cap, Start engine and
allow to run for a few minutes, Re-check
oil level and ll accordingly.
1
2
Fuel level
Filler neck
FUEL
Never use leaded gasoline in this product.
It could affect the engine’s emissions and
damage the engine.
Mini Bike requires clean unleaded regular
gasoline with a minimum octane rating of
86 or higher.
Fill with gasoline up to the bottom of the
ller neck.
6
Caution: Do not over or under ll
with Motor Oil
Fill level

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Coleman CT200U and is the answer not in the manual?

Coleman CT200U Specifications

General IconGeneral
Engine196cc
Horsepower6.5 hp
Starting SystemRecoil Start
FrameSteel
Weight Capacity200 lbs
TransmissionAutomatic centrifugal clutch
Tires19x7-8

Related product manuals