Coleman Room Dome Tent User Manual

Layout & Positioning
of Tent, Pole Assembly
–Layout and position tent with doors
facing desired direction. (illus. 1)
–Stake down tent corners, using
the tent stake loops.
Keep the floor taut.(illus. 2)
–Assemble all poles by interlocking
shock-corded poles.
–Insert the longer Center Frame Poles into
Center Pole Sleeves. The poles should cross
forming an “X” in the middle of tent. (illus. 1).
–Insert the shorter Side Frame Poles through the pole
sleeves located at the sides of tent. (illus. 1).
Connect Frame to Tent
–Unzip doors
–Locate the Pin & Ring Systems on
either side of the front doors and the
corresponding Pin & Ring on the
back side of tent.
–Insert one end of Frame Pole onto
Pin & Ring System on tent stake
loop on either side of the doors (illus. 3)
–Go to opposite end of pole diagonally
from starting point and gradually
apply pressure to the pole forming an
arch until you are able to insert the
Pin into pole end.
–Repeat for second pole–Attach tent
frame clips to poles
13’x13’ 3 Room Dome Tent
1
2
When You Are Ready To Set Up Your
Tent
–Select a level campsite clear of rocks,
branches and other hard or sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions,
position the end of tent into the wind.
–See owners manual for more tips.
Side Tent
Poles
Rainfly Pole
Rainfly Part No. 9270A104
Center Tent
Poles
POLE ASSEMBLY PARTS
Door
Door
Instructions apply to Part Number 9270B133
illus. 1
illus. 2 Tent
stake through
stake loop
illus. 4
Center section upright
Part No. 9270-102
Part No. 9270-105
Part No. 9270-103
Illus. 3
Ring & Pin System
Center poles
Side pole
Side pole
Center poles
Sidepole
Sidepole

Coleman Room Dome Tent Specifications

General

Brand	Coleman
Model	Room Dome Tent
Category	Tent
Language	English

Summary

Setting Up Your Tent

Layout and Positioning

Position tent with doors facing desired direction, stake corners, and assemble poles.

Connect Frame to Tent

Insert frame poles into pin and ring systems, forming arches, then attach frame clips.

Raising and Securing the Tent

Raise Ends of Tent

Insert side frame poles into pin and ring systems and attach frame clips.

Attach Rainfly

Assemble rainfly poles, insert into pockets, tie to tent poles, drape rainfly, and secure guy lines.

Important Usage and Care Information

Condensation Management

Minimize condensation by ensuring good ventilation and removing wet items from the tent.

Tent Storage and Maintenance

Dry tent thoroughly before storage; do not store poles telescoped.

Safety Precautions

Keep flame and heat sources away from tent fabric; do not leave tent set up in sun for extended periods.