Colortrac SmartLF Ci 40E

Need help?

Do you have a question about the Colortrac SmartLF Ci 40E and is the answer not in the manual?

Summary

SAFETY PRECAUTION

OPERATING ENVIRONMENT

Scanner Box Contents List

CHAPTER 1 BEFORE USING THE SCANNER

1.2 Unpacking SmartLF Ci from its box

1.3 Lifting the Scanner from its carton

CHAPTER 2 PREPARING THE SCANNER AND SOFTWARE

2.1 Connecting the power and interface cable

Details on connecting the scanner to power and the computer via interface cable.

2.2 Connecting the scanner & preparing to load the driver

2.4 Installing the SmartLF All-In-One software

CHAPTER 3 USING SMARTLF Ci 40 FOR THE FIRST TIME

3.01 Loading a document using the scanner control panel

Instructions for loading documents into the scanner using its control panel.

3.02 Stopping and starting the scanner under program control

3.04 Remote control of the scanner using Windows XP

3.05 Making your first scan

Guidance on performing the initial scan operation with the SmartLF All-In-One software.

3.06 The SmartLF All-In-One SCAN-TO functions

Description of the Scan-to-File, Scan-to-Copy, and Scan-to-Email features.

3.07 Setting the scanner color modes

CHAPTER 4 SCANNER MAINTENANCE

4.1 Cleaning the CIS sensor glass

Detailed instructions for cleaning the scanner's CIS sensor glass assembly.

4.2 Cleaning the scanner roller

Procedure for cleaning the internal paper transport roller of the scanner.

4.3 Normalisation maintenance (Ci Utilities)

Performing white point calibration using the Ci Utilities for sensor accuracy.

4.4 Checking and setting scanner stitch

4.4.1 Running the automatic stitch routine

Steps for performing an automatic calibration of scanner sensor alignment.

4.4.2 Manually stitching the scanner

Procedure for manually adjusting scanner sensor alignment if auto-stitch fails.

4.5 Upgrading Ci 40 to a higher model

CHAPTER 5 CONFIGURING & USING THE ETHERNET CONNECTION

5.1 SmartLF Ethernet driver installation

Instructions for installing the necessary driver for Ethernet network connection.

5.2 Connecting the scanner with an Ethernet switch

5.4 Altering and checking the IP address

5.5 Setting and altering the IP settings - SmartLF All-In-One

5.6 Setting and altering the IP settings - ScanWorks

5.7 Setting and altering the IP settings - CopySmart

CHAPTER 6 TROUBLESHOOTING PROCEDURES FOR CI 40

6.1 Common problems

Lists and explains common issues encountered during scanner operation and setup.

6.2 Problems indicating routine user maintenance

CHAPTER 7 APPENDICES

7.1 Computer requirements for SmartLF Ci 40

Specifications for the computer hardware and operating system required for the scanner.

7.2 How to check for a USB2 interface

7.7 SmartLF Ci 40 Technical Specification