What to do if the Colortrac SmartLF Scan! 36 Scanner loaded document suddenly moves and is ejected?
If your loaded document suddenly moves through the Colortrac scanner and is ejected, accompanied by a light flashing for 1 second every 5 seconds, it indicates that the scanner has entered deep power save mode. To resolve this, place paper on the tray and then remove it to re-power the scanner.
Why does the orange light show and the Colortrac SmartLF Scan! 36 will not scan?
If the orange light is on and your Colortrac scanner won't scan, it's likely because the paper tray is open and not properly locked at one or both ends. Make sure to close the paper tray securely.
How to wake up Colortrac SmartLF Scan! 36 Scanner if blue light flashes?
If the blue light on your Colortrac Scanner flashes for 1 second every 5 seconds, the scanner is in sleep mode. To wake it up, press the SCAN button or insert media.
Instructions for preparing and powering on the scanner.
Step-by-step guide for performing the initial one-time calibration.
Instructions for downloading and installing the necessary scanner software.
Common issues and solutions for operating the scanner.
Explanation of warning icons and error messages displayed by the scanner.
List and interpretation of specific error codes encountered during scanner operation.
General| Type | Large Format Scanner |
|---|---|
| Maximum Scan Width | 36 inches |
| Optical Resolution | 600 dpi |
| Interface | USB 2.0 |
| Color Depth | 48-bit |
| Supported Media Types | Film, Mylar, Vellum |
To Next Page