EasyManua.ls Logo

Coltech MDDE-10DEN3-QA3 - Care and maintenance; Routine Maintenance Tasks

Coltech MDDE-10DEN3-QA3
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
ENGLISH
5. Position thehose in such away that thewater can drain freely. Avoid kinking and
pinching thehose.
6. Switch thedehumidifier on and press [
] until thecontinuous dehumidification
indicator (11) comes on.
7. To discontinue continuous operation, switch thedehumidifier off, unplug it and
disconnect thedrain hose.
8. Re-insert therubber plug into thedrain hose connection.
9. Plug themains lead back in and switch thedehumidifier on again.
Care and maintenance
Note: Turn thedehumidifier off and pull out theplug before cleaning or servicing it.
Clean theexterior of thedehumidifier using alightly moistened cloth. Only use mild
cleaning agents, never solvents or corrosive chemicals.
Vacuum clean theair inlet and outlet grilles of thedehumidifier.
Remove thewater reservoir (see theEmptying thewater reservoir section) every
14th day and wash it by hand using amild detergent. Rinse it with clean water.
Note: Do not wash thewater reservoir in adishwasher.
Clean theair filter every 14th day, see theAir filter section.
If thedehumidifier is not to be used for anextended period:
- Switch thedehumidifier off, unplug it, wind up themains lead and hang it on
thelead holder.
- Clean thehousing of thedehumidifier.
- Wait 24 hours before emptying thewater reservoir to ensure that all thewater
in thedehumidifier has had time to collect in it.
- Remove thewater reservoir, empty it, dry it and then refit it.
- Remove theair filter, clean and refit it.
- Store thedehumidifier in adry, well-ventilated place.