CALOR 40 Manual Page 27 (total 27) COMAC CAL s.r.o.
Form for shipment of the meter back to COMAC CAL s.r.o.
The meter you have was made with the maximum precision and it has been checked many
times and wet calibrated.
If the meter is used in agreement with this manual, the occurrence of faults is very rare.
Should they ever occur, contact our service department. If you return the meter to the
manufacturing plant, adhere to the conditions stated below:
- Clear the meter of contaminations stuck to the sensor and measuring tube
(eventually to the Evaluation Unit).
- If the meter was run with poisonous, etching, combustible liquids or with fluids
dangerous to water, check it and if appropriate, flush and neutralize the cavities
inside the sensor.
Fill in the following data please and the form duly completed attach to your consignment.
COMAC CAL s.r.o. will not be able to process your request promptly and correctly without
this form.
Customer
Company……………………………… City……………………………
Department…………………………... Name……………………………
Phone no.…………………………….
Enclosed meter
Type………………………………… Serial number………………………….
Measured liquid…………………………………….
Description of a fault or modifications required………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
We confirm that the meter was duly cleaned, and if required, it was flushed out and
neutralized. Therefore, this consignment does not constitute any risk to humans and
environment due to remnants of the measured fluid.
Date……………………….. Signature and stamp……………………….
To Previous Page
Loading...
