DAILY MAINTENANCE
29. CLEANING THE DETERGENT SOLUTION FILTER (OPTIONAL)
1. Make sure the dirty water recovery tank is empty; if necessary, empty it completely
2. Check the main machine switch is set to “OFF”
3. Disconnect the battery connector cable from the machine connector cable (battery-operated
versions)
4. Disconnect the power cable from the mains socket (electric versions)
5. Turn off the detergent solution tap
6. Unscrew the cap (1) of the solution filter
7. Remove the solution filter cartridge and clean it under running water
8. Reassemble all the elements
30. DISASSEMBLING THE DISC BRUSHES (B VERSION)
1. Activate the main switch by turning it to “ON”
2. Lift the machine by means of the handlebars
3. Press the dead man's levers (1)
4. Activate the bipolar switch by pulling the lever (2) down
WARNING: during this operation, verify that there are no people or objects
near the brush.
31. DISASSEMBLING THE DISC BRUSHES (E VERSION)
5. Activate the main switch by turning it to “ON”
6. Lift the machine by means of the handlebars
7. Pulse press the dead man's levers (1)
WARNING: during this operation, verify that there are no people or objects
near the brush.
To Next Page
Loading...
