17
Antenna cable installation
(Cp. the installation diagram on the next page)
A pair of wire strippers and a cable cutter are required for installing
the F connector on the coaxial cable.
Ö Cut 8 mm of the coaxial cable at each end up to the inner core.
Ö Carefully cut 10 mm of the outer insulation so that the wire netting
is exposed.
Ö Turn the wire netting backwards and wind it over the outer
insulation in such a manner that it does not touch the inner core.
Ö Remove the inner insulation up to 2 mm from the wire netting.
Ö Rotate the F connector onto the turned-back wire netting until the
connector touches the inner insulation.
L
The wire netting must not protrude from the back of the
connector end.
Ö Cut the inner core with a cable cutter in such a manner that it
projects maximum 1 mm from the connector.
To Next Page
Loading...
