ComAp IG-NTC-BB - Page 130

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
130
Setpoint: RS232(2)MdmIni
Group
Comms settings
Range [units]
[-]
Related FW
3.0
Description
This setpoint can be used to add extra AT commands at the end of the
initialization sequence of the modem connected to the COM2 port. The command
can be entered with as well as without the "AT" prefix, are separated with
semicolon and maximal length is 31 characters.
The setpoint can't be modified via the IG-NT built-in terminal.
Using a modem at the COM2 port is not supported since the hardware version
2.0. For modem use the COM1 port instead.
Setpoint: RS485(2) conv.
Group
Comms settings
Range [units]
DISABLED, ENABLED [-]
Related FW
3.0
Description
This setpoint selects function of the built-in RS485(2) converter.
ENABLED
The communication port COM2 is redirected to the integrated
RS485(2) converter. The RS232(2) connector has no function.
DISABLED
The communication port COM2 is present at the RS232(2)
connector.
NOTE:
The redirection is applied only for DIRECT, MODBUS and ECU-LINK modes. See
the setpoint RS232(2) mode.
NOTE:
This setpoint has no function for IG-NT(C)-BB and IS-NTC-BB as this controller
modifications do not provide the RS232 connector at the COM2 port. The port is
redirected to the RS485 interface all the time regardless of this setpoint.
Setpoint: CAN bus mode
Group
Comms settings
Range [units]
32C,8C [-]
Related FW
3.0
Description
CAN bus speed selection.
 32C: High speed CAN (250 kbps) applicable up to 32 controllers, CAN
bus length limited up to 200 meters.
 8C: Low speed CAN (50 kbps) applicable up to 8 controllers, CAN bus