ComAp IG-NTC-BB - Setpoint Groups; Setpoints - SMS;E-Mail

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
77
Setpoint groups
1. ProcCtrlSingle (SPtM, SPI)
2. ProcCtrlMulti (MINT)
3. Basic settings
4. Comms settings
5. Engine params
6. Engine protect
7. Analog protect
8. Gener protect
9. Mains protect (SPtM)
10. AMF Settings (SPtM, SPI)
11. Pwr Management (MINT)
12. Sync/Load ctrl
13. Volt/PF ctrl
14. Force value
15. Load shedding
16. Timer settings
17. Act. calls/SMS
18. Date/Time
CAUTION!
Do not perform repeated writing of setpoints (e.g. power control from a PLC by repeated writing of baseload
setpoint via Modbus) The setpoints are stored in EEPROM memory, which can be overwritten more than 10
5
times without risk of damage or data loss, but it may become damaged, when allowed number of writing
cycles is exceeded!
Setpoints - SMS/E-Mail
1. History record
2. Alarm only
3. Warning
4. Off load
5. BrkOpen CoolDn
6. Mains protect
7. Slow stop
8. Shutdown
9. ShutdownOvr
10. AcallCH1-Type
11. AcallCH1-Addr
12. AcallCH2-Type
13. AcallCH2-Addr
14. AcallCH3-TYPE
15. AcallCH3-Addr
16. AcallCH4-TYPE
17. AcallCH4-Addr
18. AcallCH5-TYPE
19. AcallCH5-Addr
20. NumberRings AA
21. ActCallAttempt
22. Acall+SMS Lang