To Next PageTo Next Page
Need help?Do you have a question about the ComAp IG-NT and is the answer not in the manual?
General| Model | IG-NT |
|---|---|
| Type | Generator Controller |
| Synchronization | Yes |
| Remote control | Yes |
| Communication | Modbus, CANopen |
| Communication Interfaces | RS232, RS485, CAN |
| Display | Graphical LCD |
| Protection | Overvoltage |
| Protection Rating | IP65 |
| Inputs/Outputs | Digital and Analog I/O |
Covers critical warnings, cautions, and guidelines for safe operation and remote control of the gen-set.
Details the behavior of the controller in OFF, MAN, SEM, and AUT operational modes.
Explains the sequence of operations for starting the gen-set engine.
Details the sequence for safely stopping the gen-set engine.
Details binary inputs for control functions like start/stop and emergency stop.
Describes binary outputs linked to fixed protections like Alarm, Horn, and Overspeed.
Covers setpoints for parallel operation modes like Baseload, Import/Export, and Derating.
Details fundamental settings like Gen-set name, nominal power, current, and CT ratios.
Covers engine parameters like starting RPM, oil pressure, and crank settings.
Details parameters for engine protection like horn timeout and run-only delays.
Explains IDMT overload protection settings and reaction times.
Details settings for generator over/under voltage and frequency protections.
Covers generator current asymmetry and earth fault protection settings.
Configures setpoints for mains over/under voltage protections.
Configures setpoints for mains over/under frequency protections.
Configures speed governor characteristics, gain, and bias for engine speed control.
Explains how to adjust load control parameters for stable parallel operation.
Configures load shedding levels, delays, and automatic reconnection.
Describes InteliMonitor capabilities for monitoring, setpoint adjustment, and history.
