ComAp IG-NTC-BB - Page 218

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
218
Description
This setpoint is used to enable sending SMS and/or e-mail alerts when a Slow
stop-type alarm occurs. See the chapter Alarm management for more information
about protection types.
Setpoint: Shutdown
Group
Act. calls/SMS
Range [units]
DISABLED, ENABLED [-]
Related FW
3.0
Force value
possible
YES
Description
This setpoint is used to enable sending SMS and/or e-mail alerts when a
Shutdown-type alarm occurs. See the chapter Alarm management for more
information about protection types.
Setpoint: ShutdownOvr
Group
Act. calls/SMS
Range [units]
DISABLED, ENABLED [-]
Related FW
3.0
Force value
possible
YES
Description
This setpoint is used to enable sending SMS and/or e-mail alerts when a Sd
Override-type alarm occurs. See the chapter Alarm management for more
information about protection types.
Setpoint: AcallCH1-Type
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Description
The setpoint is used to specify the alert type of the active calls - channel 1. See
the chapter Alarm messaging for more details.
Setpoint: AcallCH1-Addr
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Description
The setpoint is used to specify the recipient address for the active calls - channel
1. The content of the address must correspond to the selected alert type (e.g. it
must contain e-mail address if the alert type is e-mail). See the chapter Alarm
messaging for more details.