Comau Robotics Product Instruction
22
E.DO GRIPPER INSTALLATION
q. Reposition the plastic protective
cover U on the last Robot joint.
r. By means of a 2.5 mm Allen
wrench, fix again the plastic
protective cover U of the last
Robot joint by using the two
socket hex head screws V
M3x8.
After the mechanical installation of the e.DO Gripper, it is necessary to perform some
identification and setup operations via dedicated app. For further information, consult
the related user handbook of the app e.DO (see https://edo.cloud/documents/).
Operating procedure (Continued)
To Next Page
Loading...
