35
EN
4. Unpacking
4.1 Reception of packaged product
Check upon receipt that the product has not been damaged during transport. If any
damage is noticed, notify the transporter immediately.
After transport the package must be intact, that is, it must not:
-
Show dents, signs of shocks, deformation or breakages of the container.
-
Show areas that are wet or signs that would point to the fact that the casing has
been exposed to rain, frost or heat.
-
Show signs of tampering.
Check that the content of the package matches the order.
4.2 Handling
In order to prevent any damage to the device, it is recommended to
transport it exclusively inside its original packaging.
We recommend:
o
preserve original packaging for every future transport needed.
o
not to bump the device (even if still in its packaging) exposed to atmospheric
agents.
o
not to drag the device.
4.3 Product identification
Figure 5 shows the identification label containing the serial number which must always
be provided when requesting assistance, spare parts, repairs or information
concerning operation of the device.
Figure 6
It’s forbidden to remove nameplate putted on the product or
sabotaging data. In case of damage or loss, ask to the constructor a
new nameplate. Remember, the warranty it’s associated only with the
product identification number.
To Next Page