19
EN
EN
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
G
Congratulations for choosing one of our products! We would like to remind you that we took the safety
of the operator, the eciency of its use and the protection of the environment into great consideration
when designing and manufacturing this product.
In order to preserve its features over time, please read and follow these instructions carefully.
Particular attention must be awarded to the parts with the following symbol:
WARNING
as they contain important instructions regarding safety when using the high-pressure cleaner.
e Manufacturer is not liable for damage caused by:
• failure to comply with these instructions;
• use of the high-pressure cleaner not included in the list in the “DESIGNATED USE” section;
• failure to comply with current safety regulations and regulations for the prevention of accidents in the
workplace when using the high-pressure cleaner;
• incorrect installation
• failure to carry out the anticipated maintenance;
• modications or actions without prior authorisation by the Manufacturer;
• use of non-original or non-specic spare parts for this model of high-pressure cleaner;
• repairs which were not completed by a Skilled Technician.
1.1 the address of the manufacturer
e address of the manufacturer is given in the EC declaration of conformity.
1.2 use and conservatIon of these operatIng and maIntenance manual
e operating and maintenance instructions are an integral part of the high-pressure cleaner and they
must be kept in a safe place for future reference so that they may be readily consulted in case of need.
e operating and maintenance instructions contain important information for the safety of the operator
and of any people near him and for the protection of the environment.
In case of deterioration or loss, a new copy should be requested from the dealer or from an authorised
service centre.
If the high-pressure cleaner is passed on to a third party, please make sure these operating and maintenance
instructions are also given to the new owner.
We take great care when drawing up our instructions. If you note any mistakes, please do inform the
Manufacturer or an authorised service centre.
e Manufacturer reserves the right to modify, update and correct these instructions without notice.
It is illegal to copy these instructions, even partially, without prior authorisation by the Manufacturer.
1.3 symbols and terms
1.3.1 Symbols
e symbol:
WARNING
next to certain parts of the text, is to indicate that there is the rm possibility of injury to persons if the
relative instructions and indications are not followed.
e symbol: CAUTION
next to certain parts of the text, is to indicate that there is the possibility of damaging the high-pressure
cleaner if the relative instructions are not followed.
1.3.2 Terms
• Skilled Technician: a person, generally from the service centre, who has received appropriate training
and is authorised to carry out special maintenance and repairs on the high-pressure cleaner. Any work
on is electrical parts must be carried out by a Skilled Technician who is also a Qualied Eletrician, i.e.
a person with professional training who is authorised to check, install and repair electrical equipment
correctly and according to current regulations in the country where the high-pressure cleaner is installed.
• Total Stop: this stops operation of the high-pressure cleaner every time the control lever on the cleaner
To Next Page
Loading...
Need help?
General
