EasyManua.ls Logo

Comet KR 1100 - User Manual

Comet KR 1100
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
(IT)
I E  A F
(FR)
N H P É  E F
(DE)
E K-H
(ES)
H E  A F
(PT)
L  A P E 
Á F
(RU)
  
 
KR 1100
(EN)
I M
(EN)
C W, E H P C
(IT)
M ’
(FR)
N 
(DE)
B
(ES)
M  I
(PT)
M  I
(RU)

(EN)
WARNING. Do not use the device without the previous reading of the instruction leaet.
(IT)
ATTENZIONE. Non usare l’apparecchio
senza avere letto il foglio di istruzioni.
(FR)
ATTENTION. Lire la notice technique
avant d’utiliser l’appareil.
(DE)
ACHTUNG. Verwenden Sie das Gerät
nicht, ohne die Bedienungsanleitung
gelesen zu haben.
(ES)
ATENCIÓN. No usar el aparato sin haber
leído antes la hoja de instrucciones.
(PT)
ATENÇÃO. Não use este aparelho sem
antes ter lido o folheto de instruções.
(RU)
. 
  
 
.

Questions and Answers

  • A
    Alexandra BradyAug 15, 2025
    What to do if my Comet KR 1100 Pressure Washer motor suddenly stops?
    • T
      Todd AguilarAug 16, 2025
      If your Comet Pressure Washer motor suddenly stops, it might be due to the thermal relay being triggered by overheating. To resolve this, check the voltage, turn off the switch, and allow the motor to cool down for a few minutes.
  • E
    Ellen BridgesAug 18, 2025
    Why is my Comet KR 1100 Pressure Washer pump running but not building pressure?
    • D
      Deborah HaynesAug 19, 2025
      If your Comet Pressure Washer pump isn't generating pressure despite running, several issues could be the cause. First, check if the intake filter is clogged and clean it if necessary. Also, inspect the intake connection fitting and hose connectors for any air being drawn in. Furthermore, the inlet and outlet valves might be clogged or worn, requiring cleaning or replacement. Lastly, verify that the nozzle hole isn't too large and replace it if needed.
  • J
    Joseph WilliamsonAug 21, 2025
    Why is there a loss of pressure in my Comet KR 1100 Pressure Washer?
    • T
      Timothy ZhangAug 21, 2025
      If your Comet Pressure Washer experiences a loss of pressure, several factors could be responsible. Start by checking the nozzle for wear and replace it if necessary. Next, inspect the valves for dirt or clogs, cleaning or replacing them as needed. Also, examine the valve seals and other seals for wear, replacing them if necessary. Finally, check the filter for clogs and clean or replace it.
  • A
    adrienne21Aug 25, 2025
    Why does my Comet Pressure Washer pump not run when I press the switch?
    • S
      Shannon BurtonAug 25, 2025
      If your Comet Pressure Washer's pump isn't running when you press the switch, several things could be wrong. Start by checking the plug and fuses for any damage. Then, make sure the voltage is sufficient. If those aren't the problem, the pump might be locked, so try manually turning over the motor. Lastly, the thermal relay might have tripped, in which case you should let the motor cool down.
  • H
    Heather PayneAug 27, 2025
    Why is the operating pressure of my Comet Pressure Washer irregular?
    • B
      bobbysantosAug 27, 2025
      If your Comet Pressure Washer's operating pressure is irregular, it could be due to several reasons. Check the intake connectors for air being drawn in. Also, the valves may be clogged or worn, requiring cleaning or replacement. Similarly, worn seals can cause pressure irregularities, so inspect and replace them if necessary. Finally, ensure the motor stops completely after releasing the gun trigger before pressing it again.
  • M
    Mark WheelerAug 30, 2025
    Why is my Comet KR 1100 making excessive noise?
    • R
      Rachel QuinnAug 30, 2025
      If your Comet Pressure Washer is making excess noise, it could be due to several factors. Check the intake lines for air being drawn in. Inspect the valves for wear, dirt, or clogs, and clean or replace them as needed. Also, examine the bearings for wear and replace them if necessary. Ensure that the water temperature is below 50 °C. Finally, check the filter for dirt and clean or replace it.
  • D
    Douglas BassSep 2, 2025
    What to do if my Comet Pressure Washer motor hums but doesn't start?
    • D
      Debbie PrattSep 2, 2025
      If, when you press the switch on your Comet Pressure Washer, the motor hums but doesn't start, it could be due to a few reasons. Check that the mains voltage is at the specified level. Also, the pump might be blocked or frozen, so inspect it. Finally, the extension cable might be insufficient, so ensure it's adequate and replace it if necessary.
  • D
    Douglas SmithSep 5, 2025
    Why is the water from my Comet Pressure Washer mixed with oil?
    • C
      chad71Sep 5, 2025
      If the expelled water from your Comet Pressure Washer is mixed with oil, it's likely that the sealing rings (water + oil) are worn. You should check and/or exchange them.
  • V
    Vincent JosephSep 8, 2025
    Why is my Comet KR 1100 Pressure Washer leaking water from the pump head?
    • S
      Samantha Rosales DDSSep 9, 2025
      If water leaks from the pump head of your Comet Pressure Washer, it's likely due to worn seals. You should exchange the seal or the O-ring of the seal set.
  • J
    James BoyerSep 12, 2025
    Why is my Comet Pressure Washer pump dripping?
    • S
      Sean RamirezSep 12, 2025
      If your Comet Pressure Washer pump is dripping, it's likely that the seals are worn. Check and replace them, preferably at a professional repair shop.

Summary

Instruction Manual

Cold Water, Electric High Pressure Cleaner

Identifies the product as a cold water electric high pressure cleaner.

Technical Data

General Safety

General Safety Regulations and Accident Prevention

Essential safety regulations and accident prevention measures.

Using the Cleaner

Connecting and Starting Up

Operating Instructions - Connection

Step-by-step guide for connecting the hoses and accessories.

Operating Instructions - Starting Up

Procedure for starting the high pressure cleaner.

Operation and Maintenance

Operating Instructions - Correctly Using the Device

Guidance on proper handling and use of the cleaner during operation.

Operating Instruction - End of Operation

Steps to safely shut down the high pressure cleaner.

Troubleshooting

Comet KR 1100 Specifications

General IconGeneral
BrandComet
ModelKR 1100
CategoryPressure Washer
LanguageEnglish

Related product manuals