Comet KR 1100 - Operation and Maintenance; Operating Instructions - Correctly Using the Device; Operating Instruction - End of Operation; Maintenance

9
to stop completely before pressing the trigger again. Do not let go and press it immediately.
• To completely turn o the high pressure cleaner, press the ON/OFF switch on the device.
• e shape of the water jet can be changed from concentrated to at jet by turning the head-nozzle.
• Using the lance with rotating nozzle is particularly eective in cases of very stubborn dirt.
OPERATING INSTRUCTIONS - CORRECTLY USING THE DEVICE
1. e high pressure cleaner must be set upright on a level, stable surface.
2. e spray lance is aected by a thrust during operation – therefore, always hold it rmly with both hands.
IMPORTANT: Point the nozzle at the ground.
3. Activate the trigger of the spray handle.
4. Always adjust the distance and thus the pressure of the nozzle to the surface which is to be cleaned. NOTE: e
spray angle can be adjusted at the nozzle.
NOTE: Do not cover the machine during operation. If the machine is le or not used; it must be switched o on the
start. Stop switch (press the ON/OFF switch immediately).
It is normal for the pump to leak a little; this is necessary to avoid damage to the pump when it is at a standstill.
OPERATING INSTRUCTION - END OF OPERATION
1. Shut o the water supply and drain the water under pressure remaining in the machine, operate it for a few seconds
with the lever spray handle pressed.
2. Press the ON/OFF switch.
3. Disconnect the plug from the socket.
MAINTENANCE
WARNING! Always disconnect the plug form the socket prior to maintenance or cleaning.
To ensure a long and problem free working life, please take the following advice:
• wash o water hose, high pressure hose, spray lance and accessories before mounting;
• clean the connectors of dust and sand;
• rinse the detergent praying attachment aer use.
Any repair should always be made in an authorized workshop with original spare parts.
MAINTENANCE - CLEANING OF LANCE NOZZLE
A clogging up in the nozzle causes a pump pressure which is too high. is is why cleaning is required immediately.
1. Stop the machine and disconnect the lance nozzle from the spray handle.
2. Clean the nozzle. IMPORTANT: e cleaning tool should only be used when the spray lance is detached!
3. Flush the spray lance backwards with water.
EN