20
gun is released. It does not operate in the range of pressures between 0÷20 bar/0÷290psi.
• By-pass: means the particular operating mode of the high-pressure cleaner that is achieved when the
lever of the cleaner gun is released during normal operation. In this condition, the pressure gauge signals
lack of pressure and the pumped water returns to the suction unit thanks to the pressure control valve.
Due to the presence of the Total stop, (see previous description), this operating mode is only activated
in the range of pressures between 0÷20 bar/0÷290 psi, or should the Total Stop fail to operate.
• Easy Start: this aids starting up the high-pressure cleaner by lowering the pressure for the rst moments
of its operation.
F
KA Classic - KA Excel
2800 M 3000 M 3200 M 4000 T 5000 T
ELECTRICAL CONNECTION
Mains power supply 230 V / 1~ 50 Hz 400 V / 3~ 50 Hz
Absorbed power 2,6 kW 2,9 kW 2,9 kW 3,8 kW 4,3 kW
Fuse 16 A
HYDRAULIC CONNECTION
Maximum inlet water temperature 50 °C / 122 °F
Minimum inlet water temperature 5 °C / 41 °F
Minimum inlet water ow
700 l/h
185 US gph
900 l/h
238 US gph
800 l/h
211 US gph
900 l/h
238 US gph
900 l/h
238 US gph
Maximum inlet water pressure 0,8 MPa / 8 bar / 116 psi
Maximum priming depth 1,5 m / 59 in
PERFORMANCE
Water ow
540 l/h
143 US gph
720 l/h
191 US gph
600 l/h
159 US gph
720 l/h
191 US gph
720 l/h
191 US gph
Maximum pressure
14 MPa
140 bar
2031 psi
13 MPa
130 bar
1885 psi
15 MPa
150 bar
2176 psi
17 MPa
170 bar
2466 psi
20 MPa
200 bar
2901 psi
Recoil of cleaner gun 25 N 31 N 29 N 36 N 39 N
Sound level 88,2 dB (A)
Operator arm vibrations 2,30 m/s
2
WEIGHT AND DIMENSION
Lenght x width x height
(without pipe reel) 46 x 41 x 94 cm / 18,1 x 16,1 x 37,0 in
Lenght x width x height
(with pipe reel) 48 x 41 x 94 cm / 18,9 x 16,1 x 37,0 in
Weight
(without pipe reel) 37 kg / 81,6 lb
Weight
(with pipe reel) 43 kg / 94,8 lb
Detergent tank 4 l / 1,06 US gal
All features and technical specications are only indications. The Manufacturer reserves the right to modify the appliance as it deems necessary.
2.1 IdentIfIcatIon of components
Please also refer to gures 1 to 4, which are located at the start of these operating and maintenance
instructions.
To Next Page
Loading...
Need help?
General
