To Next PageTo Next Page
Need help?Do you have a question about the COMINOX STERILCLAVE 18 Series and is the answer not in the manual?
General| Category | Laboratory Equipment |
|---|---|
| Chamber Volume | 18 Liters |
| Power Supply | 220-240V, 50/60Hz |
| Type | Autoclave |
| Material | Stainless steel chamber |
| Safety Features | Door locking system |
Signals chamber temperature is not suitable for starting or running the unit.
Signals water conductivity has exceeded acceptable levels in demineralisation.
Signals issue with water self-charge system (mains or external tank).
Signals the waste water recovery tank is full and needs emptying.
Signals the door was not correctly closed, preventing cycle start.
Indicates STOP key pressed before cycle end; load is not sterile.
Signals unit lost power during cycle and power has been recovered.
Signals paper missing or printer door not closed on optional printer.
Informs that distilled or demineralised water is missing in the clean water tank.
Alarm for units with demineralisation; water conductivity is too high.
Indicates time to recover water level in the chamber was overcome.
Informs about safety thermostat operation; circuit on coils is not closed.
Informs that steam or over-heated steam is coming out from the chamber.
Informs about a small steam loss, resolvable with remedies for insufficient steam.
Informs that the temperature inside the chamber overcame 150°C.
Signals that during pre-vacuum phase, pressure did not reach set value.
Signals that depression is missing inside the chamber during vacuum pulse.
Indicates level probes are not correctly operated, detecting liquid incorrectly.
Alarms signal loss of compliance with sterilisation temperature band tolerance.
Lists all alarm codes with their corresponding type and description.
Addresses issues with no information displayed or poor visibility of displayed information.
Describes how to clean and check level probes to ensure correct fluid detection.
Details how to adjust door closing to fix leakage or loss issues.
Addresses unsatisfactory drying results at the end of the cycle.
Deals with slow pressure increase during the cycle, often related to air filter issues.
Troubleshooting steps when the optional printer is not functioning.
Step-by-step procedure for assembling and installing the optional printer kit.
Troubleshooting for the optional water self drain system not functioning correctly.
Explains potential causes for steam loss from the safety valve, including altitude.
Description of the logic motherboard, its components, and installation.
Shows the electric wiring diagram for the logic motherboard.
Description of the power electronic motherboard and its components.
Shows the electric wiring diagram for the power motherboard.
Provides the electric wiring diagram for specific models.
Provides the electric wiring diagram for the 24BHD model.
Shows the hydraulic wiring diagram for specific models.
Shows the hydraulic diagram for the 24 BHD model.
