6
1) Call from Lobby phone
① When receiving a call from the lobby phone, sound COMMAX chime and the visitor's image
will be shown on the screen. (Chime rings 2 times.)
② Hold a handset to make a conversation
③ Pressing "Door release" button to open the common entrance during a conversation.
④ When conversation is over without door release, put a handset to end the
conversation.
2) Call a sub-units (Intercommunication)
① Hold a hand set and press "Interphone"call button to call a sub unit.
(All call to both Master and Slave unit)
② When the sub unit responds, conversation occurs.
(When trying to call the Guard station or other sub units during intercommunication,
nothing happens.)
③ During extension call, if a call made from lobby phone, you have the image of visitor
with lower call sound.
(Talk duration is 30 seconds)
④ Start conversion with Lobby phone after ending extension call.
(Only one extension can have a conversation with Lobby phone at the same time)
3) Call a Guard Phone (Porter)
Calling Guard phone
① Hold a hand set and press "Guard Call" button.
② When the guard responds, conversation occurs.
(In case of Porter connection, calling porter is available only. It is impossible to
receive a call from porter).
(Hear the buzz sound if the guard or porter is on the phone with other residence.)
4) Receiving a call from Guard phone
① When the guard phone call a residence, sound chime for 30 minutes without image.
② When the residence responds, conversation occurs.
③ Put the hand set to end the communication.
5) Call / Talk duration
This is applied to all call and conversation.
① Calling time lasts for 30 seconds.
② Talking duration lasts for 60 seconds.
5. Basic use
To Next Page
Loading...
